new holland ts100 problem

[faz192]

I have a ts100 and the linkage light flashes when the clutch pedal is held in.
I have checked draft pins and
potentiometers both target and actual
have cleaned earth points from linkage cover to cab and the earth point behind the left hand console cover
any suggetions

 

[banjodunn]

G'day Faz does it give you a code type flash i.e 2 flashes pause then 3 flashes would be code 23? If it does then come back with the code . I am in Ararat and I will have a look in my book tomorrow when I get to work.


Jon

 

[faz192]

cheers I will have a look tomorrow

 

[faz192]

there is no sequence to the flashes it only seems to occur when the clutch is full depressed for about 5 seconds it triggers switch or bottom of clutch switch any help would be appreciated

 

[banjodunn]

G'day faz I can't find anything in my book as to your fault, does it stop the tractor from operating at all? Sorry i"m not much help


Jon

 

[faz192]

it just stops the linkage from working until ignition is cycled then works ok again until clutch is held down again