New Kioti NS6010 and loader is not level

[drunderw]

I had a new NS6010c HST delivered yesterday. Looking at the loader when raising and lower it I noticed it appeared to be higher on one side than the other. I could tell this as it passed the brush guard in the front and wasn't in line with it. Putting a level on it I can tell that it's not level. It's not off by much but my old tractor the bucket was never level and this was a pet peeve of mine that I wanted to alleviate with the new tractor. What could cause this, what can I check and should this be of concern on a new tractor?

https://imgur.com/a/OFGval1

 

[part-time-Farmer-NC]

Are you on level ground when you checked it? How much is it off?

 

[drunderw]

I'm going to drive up to the gas station later when I get off work to check it out on their flat concrete pad. I checked it in the middle of the county road in front of our house. It seemed about 1" off but I'm taking a tape measure and tire gauge to check rear tire pressures based on some feedback that it could also be related to rear tire pressure.

 

[part-time-Farmer-NC]

You can put the level on the pad to ensure it's level as well.