New project

[BigDogues]

</font><font color="blue" class="small">( This stuff looks like aluminum, but it is a lot tougher, don't know what it is, it's really stiff. )</font>
What you probably have there is a piece of 6061-T6 aluminum. Be careful if you try to bend a 90 degree angle in that stuff. Too sharp a bend radius and it will break.
Hmmm, my guess is "The worlds largest cookie cutter" /forums/images/graemlins/grin.gif

 

[TBDonnelly]

I recognize that. It's a 'tire-sleeve'. Makes your tires flat-pruf. They don't get very good traction though, unless you put some studs in them. /forums/images/graemlins/tongue.gif

Don

 

[milkman]

The bars are wearing down on my front tires. (that's the excuse I used) /forums/images/graemlins/grin.gif

 

[milkman]

Everybody knows it's cheaper to get a full set than buy just a pair at a time right?

 

[Maine_Polack]

I donno...The pic. of it bent in the vise make me think you were making commas, or perhaps question marks.

Then came the pic. of it in a circle, so it had to be you were making periods, or the bottom of the , /or ?

Is there a prize?

 

[milkman]

Here's one side finished, have to fix a leak around the bead on the other side before I fasten the other side on.

 

[milkman]

The rings I made fit just inside the lip of the wheel.

 

[milkman]

Clamped together with four lengths of 1/2" allthread.

 

[HomeBrew2]

I like the way you think !!!! /forums/images/graemlins/grin.gif
Cheers!

 

[ruglad03835]

That looks sick!!! In a good way.. I like it.... /forums/images/graemlins/grin.gif