new rear remotes, 3 PH won't raise
- Thread starter stuwik
- Start date
- Views: 2851
J_J
Super Star Member
- Joined
- Sep 6, 2003
- Messages
- 18,952
- Location
- JACKSONVILLE, FL
- Tractor
- Power-Trac 1445, KUBOTA B-9200HST
A PB sleeve is designed to block the fluid from the cyl ports and pass the pump flow through the PB fitting for use downstream. If you don't have the PB fitting, then go to the valve manufacture and find the correct PB sleeve.
J_J
Super Star Member
- Joined
- Sep 6, 2003
- Messages
- 18,952
- Location
- JACKSONVILLE, FL
- Tractor
- Power-Trac 1445, KUBOTA B-9200HST
Chilly807
Elite Member
They're also known as high pressure carry over adapters, most European companies refer to them as that.
Sean
J_J
Super Star Member
- Joined
- Sep 6, 2003
- Messages
- 18,952
- Location
- JACKSONVILLE, FL
- Tractor
- Power-Trac 1445, KUBOTA B-9200HST
There should be more numbers. Look at page 6 that describes a P40 valve.
http://hydraulic-vlv.com/files/P40_04_ 2010.pdf
On this valve, N port is the high pressure carry over.
Probably same as your valve.
http://hydraulic-vlv.com/files/P40_04_ 2010.pdf
On this valve, N port is the high pressure carry over.
Probably same as your valve.
kennyd
Advertiser
A picture would sure help, on most valves you can't even hook up the PB hose if the sleeve is not in place since the hose actually connects to the sleeve.
Chilly807
Elite Member
I think the threads into my valve were #8 ORB, I added the adjustable elbow and converted to #6 JIC for the hose end.
Am I correct in saying that the plug remains in place (where the PB sleeve goes) if the valve is the last one in the circuit? It makes sense that way to me, but according to the wife, my logic is fundamentally flawed at the best of times.
Sean
kennyd
Advertiser
It really depends on the valve...and not being familiar with the Badestnost brand I can't say, that's why a picture would be nice.
