New toolbox

[gumshu]

I picked mine up from Mills Fleet Farm . It's a regular tractor toolbox .All seems are sealed and is suposed to be weather proof.

Turbo660, did you use the Universal mounting brackets that came with it?

 

[turbo660]

Turbo660, did you use the Universal mounting brackets that came with it?

nope, just drilled holes to line up with the existing holes in the tractor.

I did make some 1/2" thick spacers to put under it. Given the size of the tool box there are a couple of bolt heads that prevent it from sitting flat on the bottom. Took an old tire and used a 1 1/2" hole saw and drilled through the sidewall.

And for anyone that finds it difficult to access tool boxes behind the seat, just remember the seat flips forward.

 

[gumshu]

nope, just drilled holes to line up with the existing holes in the tractor.

I did make some 1/2" thick spacers to put under it. Given the size of the tool box there are a couple of bolt heads that prevent it from sitting flat on the bottom. Took an old tire and used a 1 1/2" hole saw and drilled through the sidewall.

And for anyone that finds it difficult to access tool boxes behind the seat, just remember the seat flips forward.

Thanks Turbo660. I was also thinking of pulling the hazard refelctive sign off for easier access.

 

[lilranch2001]

if you have the "slip on" bracket for the SMV sign you can do either - or, or both.
I have found when I am in the tool box a lot, I slip my SMV sign off, it seems to be more convienent

 

[beltfed]

My toolbox hits right against the SMV mount so I think I'm going to use double sided tape and mount to the back of my seat. It should fit just fine and clear the toolbox and still be very visible.

 

[gumshu]

if you have the "slip on" bracket for the SMV sign you can do either - or, or both.
I have found when I am in the tool box a lot, I slip my SMV sign off, it seems to be more convienent

Thanks. I'll have to check on that. I never bothered to look.

 

[lilranch2001]

finally got the pics of my tool box uploaded, I drilled and attched the SMV bracket to the face of the tool box, it stiffened up the "tinny" toolbox and it also gives me a quick and easy meathod for removing the SMV sign if I want to

 

[tinman955]

Nice boxes guys!!:thumbsup:

 

[NOTV8]

My CT235 is getting deliver tomorrow... will this mean I need an upgraded tool box too? :confused3: What do you guys put on it? I have a lot of tools in my garage and it won't fit on any of the tool boxes shown