Peddle Resistance on HST

[StuartT]

My 2009 L2800 is developing a resistance when depressing the FWD/REV peddle in the forward direction. Once it gets past approximately 25% of movement, it becomes easier up through full peddle, but that initial resistance is getting worse. If this sounds like a transmission problem, it is going to the dealer. But if it is more likely to be binding linkage or a dry peddle pivot shaft or such, I would feel comfortable probing deeper myself. Any one have any experience with or thoughts on this?

 

[5030]

Time to oil the pivot mechanism. Had the same issue on my Kubota F Series diesel front mount mower but mine was backing up, not going forward and all it needed was some oil on the pivot and a shot of grease to finish it up. My mower has a grease fitting on the pivot that I somehow missed.

 

[StuartT]

That is encouraging. I lube the tractor fairly regularly but the peddle pivot arm is buried up in the linkage and I could have easily missed it last time (or multiple times for that matter). I'll crawl under there and give it a shot or two. Thanks for the suggestion.

 

[Gem99ultra]

That is encouraging. I lube the tractor fairly regularly but the peddle pivot arm is buried up in the linkage and I could have easily missed it last time (or multiple times for that matter). I'll crawl under there and give it a shot or two. Thanks for the suggestion.

It's easy to overlook the 3 zerks underneath, one each for clutch, brake and throttle pedals - but they're there. I have to use a flashlight to find mine, but they're there and they do need grease every so often.

 

[old and tired]

The top one in the photo, is the hst pedal, the zerk is facing more forward vs. the other 2 which face more downward...

 

[StuartT]

Whoa, that is a surprise. I have been missing that top one. Nothing like a picture, thank you very much Mr. Old and TIred. That tractor will be in the garage today!

You started the ball rolling Gem99ultra. My thanks go to you too.