ctpres
Gold Member
"Found" some hardpan while setting posts for new front fence and got auger stuck.. Hole one, dug down around auger about a foot and it pulled out. Hole two, had to dig down almost three feet and ended up using 12" pipe wrench w cheater. Hole three, left engine running with up pressure on 3pt and used 4x4 8 foot as pry bar on side of PHD tran. housing. It's hole three technique for me from now on. Can't find way yet to get a hole in hardpan w/o getting bit stuck. Once bit hits hardpan I can't hit clutch fast enough to stop it. Only running 1,500 rpm and pulling out every few inches Any ideas?