LBrown59
Super Star Member
- Joined
- Oct 27, 2004
- Messages
- 16,831
- Tractor
- 2003 Kubota BX1500/2004 Kubota Bx23/2005 Kubota BX1500
Brasswhitearrow said:
Plastic
Nylon
Stainless steel.
pipe fittings for use with diesel fuel
- Thread starter whitearrow
- Start date
- Views: 44518
Plastic
Nylon
Stainless steel.
markct
Platinum Member
- Joined
- Aug 9, 2002
- Messages
- 893
- Location
- northfield connecticut
- Tractor
- gradall g3r excavator, kawasaki mule 2500,ford 8000,and a 1936 caterpillar road grader
ya forgot the most common choice for diesel, black iron.
LBrown59
Super Star Member
- Joined
- Oct 27, 2004
- Messages
- 16,831
- Tractor
- 2003 Kubota BX1500/2004 Kubota Bx23/2005 Kubota BX1500
Copper
least favored Black Pipe.
Raspy
Veteran Member
- Joined
- Dec 16, 2006
- Messages
- 1,636
- Location
- Smith Valley, Nevada
- Tractor
- NH TC29DA, F250 Tremor, Jeep Rubicon
Some people have said, over the years, that galvanized fittings should not be used with diesel. I have never worried about it and don't know of any problems from using it.
Galvanizing is just a plated on or hot dipped layer of zinc over the base metal iron or steel. It might dissolve slowly into the fuel, I don't know.
Use copper, brass, iron or steel fittings and piping. Or use hose that is rated for fuel and brass barbed fittings. Use them together without fear of electrolysis, as fuel is not an electrolyte like water. Galvanized piping outside might be a better compromise than black iron because you won't have to paint it (except at the joints where some threads are showing).
Use pipe joint compound rated for fuels or teflon tape. Don't get any compound inside the pipe or even on the end of the pipe, only on the male threads. Don't over tighten joints using teflon tape. It is such a good lubricant that you can split a fitting before it feels tight.
For short term, non critical uses, Vinyl tubing works well too. It doesn't seem to be affected by diesel, but is not very strong or fire resistant. Never on a vehicle or for a permanent installation, or near heat. But for a fill hose on a can or a quick hookup for testing, it's fine. I've had pieces of it in service for years.
Galvanizing is just a plated on or hot dipped layer of zinc over the base metal iron or steel. It might dissolve slowly into the fuel, I don't know.
Use copper, brass, iron or steel fittings and piping. Or use hose that is rated for fuel and brass barbed fittings. Use them together without fear of electrolysis, as fuel is not an electrolyte like water. Galvanized piping outside might be a better compromise than black iron because you won't have to paint it (except at the joints where some threads are showing).
Use pipe joint compound rated for fuels or teflon tape. Don't get any compound inside the pipe or even on the end of the pipe, only on the male threads. Don't over tighten joints using teflon tape. It is such a good lubricant that you can split a fitting before it feels tight.
For short term, non critical uses, Vinyl tubing works well too. It doesn't seem to be affected by diesel, but is not very strong or fire resistant. Never on a vehicle or for a permanent installation, or near heat. But for a fill hose on a can or a quick hookup for testing, it's fine. I've had pieces of it in service for years.