poor man's brush grappel

   / poor man's brush grappel #1  

damon c

New member
Joined
Mar 14, 2012
Messages
6
Location
huntsville alabama
Tractor
JD 4310
Hi,

I have a lot of brush to move and was wondering if anyone had any advice on using forks attached to a frond end loader? I seem to remember where someone suggested that you could use a ratchet strap and tighten it down around the load. Any ideas for a poor man's grappel?
 
   / poor man's brush grappel #2  
I've done it with a rope/chain before. Run the forks under the pile, lift pile and slide under rope/chain with one end attached to bucket. Throw the other end over the pile and and tie off to bucket hook. It's not the most efficient program but it does work.

Since I don't have a grapple I usually just lay down a choker and stack the brush on it as I cut then drag the whole thing to the pile.
 
   / poor man's brush grappel #3  
ive done something simular. Ive put down my chain, stacked brush on it, sinched it up with a slip hook and lifted the whole mess with the chain on the FEL bucket
 

Tractor & Equipment Auctions

Forklift Safety Basket Attachment (A53421)
Forklift Safety...
2015 Chevrolet Silverado 1500 Pickup Truck (A53422)
2015 Chevrolet...
2013 John Deere 35D Mini Excavator (A52377)
2013 John Deere...
MISC PALLET OF SPM PUMP PARTS AND JOSES (A53843)
MISC PALLET OF SPM...
2017 KUBOTA SVL75-2 SKID STEER (A52705)
2017 KUBOTA...
2015 JEEP PATRIOT (A51406)
2015 JEEP PATRIOT...
 
Top