Posthole Digger PTO post hole digger Vs Hydraulic Post hole digger
- Thread starter kcook
- Start date
- Views: 9637
rambler
Veteran Member
- Joined
- Jul 6, 2003
- Messages
- 1,994
- Location
- MN
- Tractor
- Ford 960, 7700, TW20, 1720; IHC H, 300; Ollie S77
Hyd costs 3x or more - big disadvantage.
It is more forgiving - won't shear as many pins as the hyd will bypass if you hit something unmovable. As well you can reverse the auger if it gets snagged - need to use a pipewrench & do it manually with a pto unit.
--->Paul
It is more forgiving - won't shear as many pins as the hyd will bypass if you hit something unmovable. As well you can reverse the auger if it gets snagged - need to use a pipewrench & do it manually with a pto unit.
--->Paul
dfkrug
Super Member
- Joined
- Feb 3, 2004
- Messages
- 7,586
- Location
- Santa Cruz Mtns, CA
- Tractor
- 05 Kioti CK30HST w/ Prairie Dog backhoe, XN08 mini-X
I have both, but I am adapting a Worksaver hyd PHD to
my backhoe, which gives it much more flexibility. It can also
be used on a 3-pt frame. The cost of the Worksaver 714H is
about $1500, and the HD mechanical 3-pt unit (# 500) is about $550, without augers.
my backhoe, which gives it much more flexibility. It can also
be used on a 3-pt frame. The cost of the Worksaver 714H is
about $1500, and the HD mechanical 3-pt unit (# 500) is about $550, without augers.
MMM
Platinum Member
Need to make sure you have the required flow. A hyd phd is a little more expensive than a QUALITY pto unit, but is reversible, and self centering which is great for deep holes(3pt trajectory) and hilly ground. Most are fel mounted which saves the neck. A hyd is a bit more complicated and requires power beyond and extra valve. Mine has a 12v directional valve wiring to worry about. I thnk a hyd will handle a larger bits like my 24" amd 36". Ive never tried them on the pto auger as they don't fit.
rmonio
Platinum Member
I have a Greenline EM5000 3-Pt PTO-driven PHD for my JD4600. This fall I drilled over 150 holes (1300ft on 8ft centers - 3 ft deep) for my perimeter PVC 3-rail fence and other than minor issues with some rocks, the drilling went without major hiccups. The cost was reasonable - purchased through my local JD Dealer - and is comparable to what one would buy a Speeco unit through TSC for. Naturally it requires that you be a bit more careful when drilling as the downward pressure isn't there (unless you have the hydraulics back there), but it did a good job for me. I am going to install another 750-1000 ft of fence this next year and aside from having sheer pins available, I believe this to be just fine for my use. I quite frankly don't know why I'd need the hydraulic unit otherwise..... /forums/images/graemlins/confused.gif
Good luck with your selection!
-Bob
Good luck with your selection!
-Bob
