kruszert
Bronze Member
I am getting parts together for make a PTO stump grinder similar in design to the Worksaver SG-26. I have most of the main parts, wheel, gearbox, hydraulic cylinder, I have the specs and parts diagram for the Worksaver but it would be helpful if someone who actually has a Worksaver could give me a few basic dimensions.
specifically:
1. width and height of the frame that connects to the 3 pt hitch
2. size tubing used for the support arm
3. plate thickness that the gearbox bolts to
My next stop is the scrap steel yard!
Any help would be appreciated. I have a Kioti DK 35 so I believe I have enough power to do the job especially since my model will be a little smaller than the Worksaver.
Thanks,
Reggie
specifically:
1. width and height of the frame that connects to the 3 pt hitch
2. size tubing used for the support arm
3. plate thickness that the gearbox bolts to
My next stop is the scrap steel yard!
Any help would be appreciated. I have a Kioti DK 35 so I believe I have enough power to do the job especially since my model will be a little smaller than the Worksaver.
Thanks,
Reggie