PTO water pump

[Sawyer Rob]

I'd go PTO if I needed something like a 4" pump. I don't think a 2" PTO pump is worth the wear and tear on my tractor.

What kind of wear and tear are you talking about??

IF a little 2" pump is wear and tear on your tractor, you should have picked a higher quality tractor in the first place.

SR

 

[mikester]

What kind of wear and tear are you talking about??

IF a little 2" pump is wear and tear on your tractor, you should have picked a higher quality tractor in the first place.

SR

Engine hours. Service intervals. Fluids and filters. Diesel.

Last time I checked none of these were free. I don't see sense in running a $100K tractor at $20/hr to drive a $500 PTO pump when a $180 disposable chinese pump will do.

I also don't mow my lawn three times a week.

 

[JethroB]

There used to a lot of towable pumps around here before pivots came along. Check farm equipment auctions or farmers junk piles. My dad had one similar to this for irrigating from the pond, and priming it was an ordeal.

 

[rScotty]

There used to a lot of towable pumps around here before pivots came along. Check farm equipment auctions or farmers junk piles. My dad had one similar to this for irrigating from the pond, and priming it was an ordeal.
View attachment 782298

That looks about perfect. I'd like to find one myself.
rScotty

 

[Sawyer Rob]

Engine hours. Service intervals. Fluids and filters. Diesel.

Last time I checked none of these were free. I don't see sense in running a $100K tractor at $20/hr to drive a $500 PTO pump when a $180 disposable chinese pump will do.

I also don't mow my lawn three times a week.

Your tractor cost 100K??? I'm thinking the OP's didn't and neither did mine.

I have no problem running mine doing small jobs. It just doesn't cost me that much to do so and surely not 20 bucks an hour to run it.

I've left mine sitting charging the battery, didn't cost me 20 bucks an hour to do so!

SR

 

[scootr]

I might have to make one up on a receiver hitch skid... yeah time to look for a bare 2-3" pto pump.

 

[rScotty]

What kind of wear and tear are you talking about??

IF a little 2" pump is wear and tear on your tractor, you should have picked a higher quality tractor in the first place.

SR

Higher Quality?? He has an M59... and medium size tractors just don't come any higher quality than that - though I might be a wee bit prejudiced. Or maybe just spoiled.

Pre-emisions industrial engine, 6 speed hydrostat, super heavy construction. Even the FEL specs are amazing.

We use ours for chores large and small both. It doesn't seem to age.

rScotty

 

[LouNY]

Many of the water pumps or trash pumps will have a hard time priming with any lift.
One way often used to prime irrigation pumps was with a gas engine vehicle as a vacuum source,
a hose from the intake manifold to a valve at the inlet of the pump with the discharge valve closed,
use the trucks engine vacuum to suck the water up and fill the pump body, close the vacuum line then start the pump and crack
the discharge valve open and the water was pumping.
Especially the 4-8 inch pump suction lines with the semi-trash pumps even with just a 1 to 6 foot of lift can be very difficult to prime.

 

[Sawyer Rob]

Higher Quality?? He has an M59... and medium size tractors just don't come any higher quality than that - though I might be a wee bit prejudiced. Or maybe just spoiled.

Pre-emisions industrial engine, 6 speed hydrostat, super heavy construction. Even the FEL specs are amazing.

We use ours for chores large and small both. It doesn't seem to age.

rScotty

Then why worry about putting a few hours on it?

I would never worry about putting some hours on a high-quality tractor, it's going to run so many years it's a non-issue!

SR

 

[kneedeep]

I use a PTO pump to drain Duck holes