PTO won't engage

[Seon]

Re: PTO won\'t engage

No PTO selector. Just a pull/push knob on the right side beside the 3pt up/lower slide control.

I just removed the backhoe from the tractor. I grabbed the PTO shaft to turn it, but it only turns a little bit then "clink" like there's a stop internally, preventing it from turning anymore. It also "clink" going the opposite direction.

BTW here's a pic of the backhoe on the JD.
pic

 

[Seon]

Re: PTO won\'t engage

No PTO selector. Just a pull/push knob on the right side beside the 3pt up/lower slide control.

I just removed the backhoe from the tractor. I grabbed the PTO shaft to turn it, but it only turns a little bit then "clink" like there's a stop internally, preventing it from turning anymore. It also "clink" going the opposite direction.

BTW here's a pic of the backhoe on the JD.
pic

 

[RalphVa]

Re: PTO won\'t engage

Here's the phone number I used to order my CD manual: 800-522-7448

Ralph

 

[RalphVa]

Re: PTO won\'t engage

Here's the phone number I used to order my CD manual: 800-522-7448

Ralph

 

[Seon]

Re: PTO won\'t engage

Thanks for the number. I'll call tomorrow and order one.

BTW is the repair manual in a CD version better than one in hard copy? Is it "user friendly"? Just curious... Thanks

Seon

 

[Seon]

Re: PTO won\'t engage

Thanks for the number. I'll call tomorrow and order one.

BTW is the repair manual in a CD version better than one in hard copy? Is it "user friendly"? Just curious... Thanks

Seon

 

[Mopardan]

Re: PTO won\'t engage

I just worked on my JD 4410 and had a bad solenoid on the dirverter. Its called a control valve. The front one goes to the 2 wheel drive switch. The rear one goes to the PTO. My PTO one had 11.1 ohms resistance and was good. My 2 wheel drive one was 0 ohms, and had gone to ground blowing a fuse. I paid $33 for the control valve and took about 30 mins to replace it. You can just unplug the wires and check resistance without taking it off. Hope this helps. /forums/images/graemlins/wink.gif

 

[Mopardan]

Re: PTO won\'t engage

I just worked on my JD 4410 and had a bad solenoid on the dirverter. Its called a control valve. The front one goes to the 2 wheel drive switch. The rear one goes to the PTO. My PTO one had 11.1 ohms resistance and was good. My 2 wheel drive one was 0 ohms, and had gone to ground blowing a fuse. I paid $33 for the control valve and took about 30 mins to replace it. You can just unplug the wires and check resistance without taking it off. Hope this helps. /forums/images/graemlins/wink.gif

 

[Seon]

Re: PTO won\'t engage

Where's the solenoid located? I don't have a manual to use as a reference.
Thanks

 

[Seon]

Re: PTO won\'t engage

Where's the solenoid located? I don't have a manual to use as a reference.
Thanks