Sweptwing
New member
Hey everyone! Recently I bought a 2015 x1100c with a factory v plow. It has not been well maintained well though it runs well. I bought it knowing I was going to have to do some work. I am rebuilding the suspension and driveshafts because the previous owner apparently didnt own a grease gun. Seriously never been greased yet it’s not as bad as one would think. However here is my issue. I can’t seem to get the rear cv driveshafts out of the gear case. There isn’t a good place to safely pry and I’m worried if I try to get too aggressive with them something will break and then I will be in trouble. Kubota wants over $600 for new rear shafts so want to be sure I can get these out before I order them. Any help would be greatly appreciated. Thanks in advance everyone.