Rear remotes

[J_J]

If your hyd block looks similar.

If not, there are ways to connect things up in a logical order.

Show us some pictures of your hyd block.

What type remotes are you wanting to install?

How many spools?

L2800 hyd

Hydraulics:
Type: open center
Capacity: 7.3 gal [27.6 L]
Valves: 0 to 3
Pump flow: 6.8 gpm [25.7 lpm]
Total flow: 11.1 gpm [42.0 lpm]
Steering flow: 4.3 gpm [16.3 lpm]

 

[Paul Thornton]

Looks like I have the same block. I will be paying attention.

L2800 w/FEL - 72" Land Pride rake

 

[Paul Thornton]

Sorry, didn't answer all questions. At this point I have no plans or need. I am in learning mode.

L2800 w/FEL - 72" Land Pride rake

 

[dlg449]

Hang in there, buddy. I'll ask the dumb questions and we'll get through together.

 

[Leejohn]

Yours is the same and well be plumped the same. Real easy to do. The hard part is where you want to mount your valve.

 

[k0ua]

This thread from a user with an L2800 may help some

http://www.tractorbynet.com/forums/...7948-instructions-add-extra-spools-l2800.html

 

[k0ua]

View attachment 310090

Looks like I have the same block. I will be paying attention.

L2800 w/FEL - 72" Land Pride rake

From what I remember the green one is Power beyond, and you take it loose, and put it in the input of your valve stack and the output/PB of you valve stack goes back to where you just took the green fitting off of. and the tank gets "teed" into the gray one. Like I said that is what I remember, but don't quote me

James K0UA

 

[Leejohn]

Thats the way it goes.

 

[dlg449]

All,
You have gone to a lot of work to pull together all this information and I greatly appreciate it. Maybe one of you with more computer literacy than me can figure out how to keep it together in a single file so it will come up on a search. It would be a shame to have to go through the whole process again when the next guy asks the question.
I ordered the valve and PB yesterday afternoon. I will document with photos and as much detail as necessary the installation but it will be a long process. I usually get home every other weekend but I'm usually pretty busy catching up on stuff around the place.
Thanks again for all the help.

 

[J_J]

Save this picture in your picture folder.

The Kubota tech at Kubota dealership told me that a good many tractors use that configuration.

He said there is also another way to connect additional ports, but I will have to check on that setup.

If only the manufacturers would show a hyd diagram with every tractor, it would be a big help in figuring things out.