Replaced turnbuckles with telescopic stabilizers

[CHDinCT]

Not sure if this is relevant, but for the BX2200 the stabilizers open and close far enough to span the full adjustable width of the lift arms. In other words, the lift arms run out of adjustment in narrowness and greatest width before the stabilizers do.

Due to the variety of hole placements there are many, many adjustment choices between the two extremes. The stbilizers will work great on my variety of implements, some homemade, that have different pin widths.

Thanks gwdixon, sounds like it will work fine for my BX25, which is the same, 3PH-wise, as a BX2360.

 

[hodge]

Thanks Mark. Will have to take some measurements tomorrow but a set of these will likely go on my want list. Seems I'm adding to the "want" list faster than I can fiscally obtain what's already on it. Got's to plant me one of those money trees one of these days. :laughing:

You and me, both. I don't take what I have and decide what I can afford, I look at what I need and figure out how much I have to save. A bigger welder is on my short list...

 

[jacobjim]

Very helpful, thanks a bunch