KennyG
Elite Member
Yeah, but I bet she doesn't know that.
Replacing bushing with bearing
- Thread starter txdon
- Start date
- Views: 5161
Yeah, but I bet she doesn't know that.
RoyJackson
Rest in Peace
- Joined
- Nov 17, 2001
- Messages
- 24,646
- Location
- Bethel, Vermont
- Tractor
- John Deere 4052R Cab,, Deere 855D UTV, Z920A Zero Turn Mower and assorted implements
Apparently, most TBNers aren't knowlegable about Oilite bearings.
For everyone's (except LD1 and I) info:
Oilite - Wikipedia, the free encyclopedia
Installing a roller bearing or ball bearing would also require some sort of seal on both sides to prevent the bearing from being contaminated. That's more complex then it needs to be.
Frankly, I'd just run the roller with the supplied bearing for a while. Considering the low speed application and relatively few hours (unless the OP is a landscaper) it would be used, it would take years to wear out the factory supplied bushing.
He could spray the bushing with Fluid Film after each use.
Last edited:
Soundguy
Old Timer
- Joined
- Mar 11, 2002
- Messages
- 52,424
- Location
- Central florida
- Tractor
- RK 55HC,ym1700, NH7610S, Ford 8N, 2N, NAA, 660, 850 x2, 541, 950, 941D, 951, 2000, 3000, 4000, 4600, 5000, 740, IH 'C' 'H', CUB, John Deere 'B', allis 'G', case VAC
any way to seal the bearing? otherwise use a sealed bearing. IMHO.. I think I'd stay with a bushing..e tc..
