Rerrir Code 50-67

[Tlysflys]

When using my tree-shear, the general warning light came on. The Toolcat (2011 F-Series) will not move forward or backwards. The error code I was able to retrieve (it first said NONE) is 50-67 "Servo Coil under Current". After the machine sits for a while, it will work again and then the light will come on again and the cycle repeats. Any advise?
Thanks

 

[Tlysflys]

Meant to say Error Code, sorry.

 

[SSdoxie]

If it starts to occur more frequently have dealer do a software update. If I remember correctly bobcat released an update to force controller to wait a little longer to verify communication with this coil. I think the update was released later part of 2015 or very early 2016.
I have retired from bobcat so can no longer get into system to look it up and be certain on this.

 

[Tlysflys]

Thanks Dennis - it started doing it every time I use the Toolcat. Also, it appears that it occurs when in reverse. I will bring the Toolcat to the dealer and ask him to update the software. However, do you know why this issue would have started just recently - I had the Toolcat for three years and it never occurred before.
Again, thank you for your input and enjoy your retirement.
TL