goosecreek
New member
- Joined
- Sep 23, 2011
- Messages
- 1
- Tractor
- John Deere 3220
I am just starting to restore a very rusted 8n. The first problem is that the rear axle is locked up, at least for one wheel. Any ideas on how to free it up?
Restoring 8N
- Thread starter goosecreek
- Start date
- Views: 1257
Soundguy
Old Timer
- Joined
- Mar 11, 2002
- Messages
- 52,424
- Location
- Central florida
- Tractor
- RK 55HC,ym1700, NH7610S, Ford 8N, 2N, NAA, 660, 850 x2, 541, 950, 941D, 951, 2000, 3000, 4000, 4600, 5000, 740, IH 'C' 'H', CUB, John Deere 'B', allis 'G', case VAC
so.. with the rear jacked up, and trans in neutral, only one wheel spins, and the other is solidly locked?
if so.. I'd be that sides axle to see if it seized to the bearing, and/or the left trumpet to check the diffy / spiders..
post back.
ps.. you have checked the brakes on that side right? to make sure they are not hung up / locked down??
soundguy
if so.. I'd be that sides axle to see if it seized to the bearing, and/or the left trumpet to check the diffy / spiders..
post back.
ps.. you have checked the brakes on that side right? to make sure they are not hung up / locked down??
soundguy
kaferhaus
Bronze Member
The brake is rusted to the drum. back the adjuster all the way out if possible and usually a few good whacks with a hammer against the face of the drum will unstick them. Obviously you'll need to remove the wheel first.