SATOH BUCK S-470D release bearing spring.

[JJVLS]

SATOH BUCK S-470D.
I"m replacing the clutch. I have it ready to slide back together. When I split it the release bearing return spring was hung up.
When I got it off the bearing did not see where it came off of the Trans tunnel. The manual I have does not show the spring.
There is a hole in the tunnel. But I cannot see any wear spot or hole it should connect to on the tunnel.
So any help is appreciated.
ullinghair: Thanks JV

 

[Roadworthy]

I can't help you myself, but if you call Valley Power you can probably get the help you need.

 

[JJVLS]

Thank you I will call them.

 

[JJVLS]

Roadworthy Thanks again.
Big shout out to Valley Power Products. They are some great people.
Called them, their Mechanic was out on lunch. He called about a 1/2 hour after my call. Now I will wait for a new spring
that I ordered from them.

 

[JJVLS]

Still can't locate where the spring attaches.
What I'm I getting into dropping the transmission tunnel?

Thanks JV

 

[JVZL1]

Well getting the tractor back together. So I'm taking my time and checking things out.
Found left brake frozen. No big deal, pulled drum leaky seal. :banghead: So the question is do you remove
the final drive case and this pushes the seal off? The manual is not to clear on this.

Thanks in advance for any input.

 

[JVZL1]

Valley Power to the rescue. :cool2: :drink: