clutchcargo
Bronze Member
How long of a shank of ripper/scarifier will work on a BX
Scarifier/Ripper Shank?
- Thread starter clutchcargo
- Start date
- Views: 1594
Gary Fowler
Super Star Member
- Joined
- Jun 23, 2008
- Messages
- 11,998
- Location
- Bismarck Arkansas
- Tractor
- 2009 Kubota RTV 900, 2009 Kubota B26 TLB & 2010 model LS P7010
The shanks should be long enough to protrude into the soil at least 4 inches. Mine have notch adjustments on 2" increments and extend about 6" below the bottom of the blade. You can get a bit more penetration by tilting the box blade forward if needed for just scarifying. If you plan to make your own, I would use at least 1/2 plate thickness, but personally I would not try to make them as they need to be tempered for hardness to avoid breaking. Too much temper and they break rather than bend and not enough hardness and they wont stand up and will constantly bend over.