Sharpening mower blades

/ Sharpening mower blades #21  
I think it would be OK to sharpen on the deck a time or two, but the blades should be checked for balance and straightness eventually.

prs
 
/ Sharpening mower blades #22  
None of the mowers I have seen give enough room to even consider sharpening in place.

And on my ZTR, its a whole lot easier to remove the blades than it is to remove the deck (or at least get it high enough to try to sharpen while leaving them on)
 
/ Sharpening mower blades #23  
On the Ventrac mowers the deck will tilt up and lock in an upright position and there is enough clearance to use an angle grinder; at least on the contour and rough mowers I have, but I zip them off with an impact wrench and sharpen on the belt sander.

prs
 
/ Sharpening mower blades #24  
None of the mowers I have seen give enough room to even consider sharpening in place.

And on my ZTR, its a whole lot easier to remove the blades than it is to remove the deck (or at least get it high enough to try to sharpen while leaving them on)
AND that's ANOTHER reason I chose a Grasshopper mower!!

standard.jpg


The "power lift deck" makes THAT maintenance job, easy!

SR
 
/ Sharpening mower blades
  • Thread Starter
#27  
Murph,
Where you get that soft cab.
Mike
 
/ Sharpening mower blades #31  
I would not like being in the open like that. How does the GH attach to it?
 
/ Sharpening mower blades #32  
Grasshopper offers a cab, with heat...

Grasshopper has a 2 point, quick attach hitch, with a pto shaft to run the mower or any other attachments...

It works perfectly!

SR
 
/ Sharpening mower blades #33  
Grasshopper offers a cab, with heat...

Grasshopper has a 2 point, quick attach hitch, with a pto shaft to run the mower or any other attachments...

It works perfectly!

SR

You have a pic of the QAH? Ventrac offers a Cab with heat but I'm not spending 5 k for it. As you see in my photo is my poor mans cab. I reverse the trans fan for some heat. Its better then being wide open to the mist the SB makes.
 
/ Sharpening mower blades #36  
Last time I priced a GH cab, it was $2,500.00 with heat, lights, and a window wiper...

I don't need it, a snow suit and goggles works just fine and as long as you aren't blowing into the wind, the blower blows the snow quite a ways away...

Because it's a zero turn, you can wiggle right in close to car's, buildings ect... It works better than I thought it would.

SR
 
/ Sharpening mower blades #37  
With the liquid cooled Kubota diesel a homemade heated cab would be an easy job.
 
/ Sharpening mower blades #38  
The GH 725D does have a heated cab which is great for winter snow blowing but I leave mine on year round. I had an upholstery shop make the vinyl windows zippered, added nylon mesh screens to keep the bugs and added a small cooling fan like those in a truck or RV to provide ventilation in summer. A rear view camera, a holder for smart phone, passive noise reduction headset and ear buds complete the set up.
 
/ Sharpening mower blades #39  
My blower is not a 0 turn but a regular CUT.

I simply take the door off in the summer and have 2ea 4" computer type 12 volt fans that blow air on me. They put out enough CFM's to also keep the insects from coming in to bite me.
 

Marketplace Items

2013 John Deere 329E High Flow Compact Track Loader Skid Steer (A61567)
2013 John Deere...
Year: 2016 Make: Ford Model: Explorer Vehicle Type: Multipurpose Vehicle (MPV) Mileage: Plate: Body (A55853)
Year: 2016 Make...
2016 RAM 5500 Bucket Truck - Cummins Diesel - Auto Trans - 4X4 - Terex LT40 Boom (A61306)
2016 RAM 5500...
2014 JOHN DEERE 648H SKIDDER (A62129)
2014 JOHN DEERE...
2003 McCormick XTX 185 XtraSpeed Tractor (A63118)
2003 McCormick XTX...
2017 Chevrolet Box 14FT Box Truck (A61568)
2017 Chevrolet Box...
 
Top