Skid Steer Quick attach specs

[Cooter Brown]

I am making a quick attach for my FEL on my tractor and was wondering if anyone new the specs on it.

I put the pins on 33 inch centers and I came up with 40 degrees for the bottom bend where the pin goes through and 45 degrees for the angle at the top of the quick attach.
I had around 15 inches for the length from the top of the 45 angle to the center of the break in the 40 degree angle.

 

[Ductape]

Does this help any?

 

[Cooter Brown]

Yes that does.
I measured off of my Takeuchi CTL and off of my attachments.My numbers match your picture.

I always wondered if there was an industry standard on these specs?

 

[J_J]

Here are some more.

 

[Cooter Brown]

Thanks Guys.I am really glad I found this site.

I will give a detailed post of my build when I am done.It is built out of mostly scraps so I doubt it will be A+ quality but it will suffice for me.
I bought material for the pins and the sleeves for them and that is it.

 

[Ductape]

There is an industry standard on the skidsteer coupler........ someone has posted it here before, but I don't recall who. You should be good to go with the measurements JJ and I have posted though.

 

[Cooter Brown]

They match what I measured on my Tak.

I want to make a quick coupler for my Kunbota excavator next for skid steer attachments.

 

[J_J]

Berlon Skidsteer Mounts

 

[mwb]

Here is the thread on one that I designed and built. I made two of these, one for my Montana and one for a Kubota L3400.

http://www.tractorbynet.com/forums/build-yourself/141029-tractor-side-shuttle-shift-quick.html

 

[Cooter Brown]

I searched for Skid Steer Quick attach and it did not come up.
I guess the SS was the problem.LOL

Nice setup but way more complicated than mine.Yours looks much more professional.