Don't really know what they call these I know I have seen them on skidsteer"s to keep bucket material from falling back when rolled back. I know my FEL will not handle the same load as a skidsteer so that will be something I will have to watch but snow will be what I use it for. So I thought I would try to make one. I have a great envy and appreciation for welders because I'm not!! Anyway it was 60F here in central Illinois and I spent the afternoon slapping this together and hope it will hold when and if it snows.
Snow ??????
- Thread starter MG1867
- Start date
- Views: 1198
Thomas
Epic Contributor
- Joined
- Apr 6, 2000
- Messages
- 31,802
- Location
- Lebanon,NH.
- Tractor
- Kubota B2650HSD w/Frontloader & CC LTX1046 & Craftman T2200 lawn mower.
That should do the trick,if you plan on removing please wait until May...your guard keeping snow away. 
The top edge of the bucket is bent. It was that way when I purchased it and i have been thinking about how to straighten it. I may need to fill the gap between the bucket and my attachment. Just need too try it out and see what I need to reengineer. Thanks for looking
