Splitter Regen Valve for Power Beyond

[Tractor Seabee]

I am looking for a log splitter regenerative valve that will work on a Power Beyond System and be stackable with others for lift and a hoist winch units. Plan to use on my BX25 using the BH ports. The Prince LSR 3060 mentioned in previous posts does not meet those criteria. Maybe I am whistling Dixie on this but need to make that decision before I proceed with my project.

Ron

 

[J_J]

The data for the LSR 2060 says

SPECIFICATIONS:
1. Max design and test pressure 3500 PSI
2. Max tank port pressure -150 PSI
3. Nominal inlet flow rating 4 gpm
4. Standard relief valve setting – 2250 psi

It doesn't say regen, but.

Perhaps you could get away with that valve, it says nominal,

I don't believe I have ever seen a log splitter valve advertised with regen.

 

[Tractor Seabee]

JJ, it is a Prince LSR 3060-3 not 2060. Cylinder Services Inc. has them, Surplus Center does not. My dilemma is continuing the PB circuit and also adding the two other circuits.

Ron

 

[J_J]

You are right on the number 3060, getting tired.

Most log splitter valves do not have a PB port.

There is one valve but it is not cheap.

1 SPOOL PRINCE AUTO CYCLE LOG SPLITTER VALVE W/PB

 

[Tractor Seabee]

Thanks J.J. Problem is the ports may be too large for my little 7 GPM BX. I am toying with using a open/close spool in a stack with the winch and lifter valves and then put the 2060 down stream from that.

Ron

 

[J_J]

You can always adapt port and hose fittings to suit your needs.