storage box location

   / storage box location #21  
Here is a shot from the side.
 

Attachments

  • 37-134182-Toolbox02.JPG
    37-134182-Toolbox02.JPG
    42 KB · Views: 220
   / storage box location #22  
I simply took a 12" peice of metal lumber, 2"x4" angle and bolted it to the top of the fender, so that it was level. Then bolted a cheap ( lowes ) plastic tool box to it. Excellant way to keep some tools, bungee cords,spare linch pins and my ever present roll of black electrical tape out of the weather.
 
   / storage box location #23  
Since I do mostly mowing with the finish mower, I attached a nice RED tool box to the arm on my mower with u-bolts up thru the bottom of the box. Holds all my spare pins, spacer bushings, etc. I don't seem to have a pic of it though.
 
   / storage box location #24  
You've gotten a ton of good advice and examples here and I won't even try to add to that. I will comment though on welding to the ROPS. Many of us here (including me!) don't believe in welding or drilling the ROPS...nothing that could remotely upset it's structural integrity. Your life may depend on it! To be honest, I'm a lot like Harv in that I don't like drilling or welding anything to the tractor unless it unavoidable. It's much easier to change your mind if you get real good with U bolts!/w3tcompact/icons/grin.gif
 

Tractor & Equipment Auctions

2014 UTILITY 53FT DRY VAN TRAILER (A51222)
2014 UTILITY 53FT...
2015 WACKER NEUSON LIGHT PLANT (A50854)
2015 WACKER NEUSON...
2001 STERLING WATER TRUCK (A50458)
2001 STERLING...
2002 International 9200i Truck (A51039)
2002 International...
2024 Case IH Magnum 380AFS CVX Connect MFWD Tractor (A50657)
2024 Case IH...
PORTER CABLE 150 PSI AIR COMPRESSOR (A50854)
PORTER CABLE 150...
 
Top