tc29 issue with rear wheels/hydro

[dynasim]

BE sure to check your tire pressure in those rears to be sure it's up to specs. I thought I had that problem, but it turned out that one of my tires was low, and the wheel was spinning, but the tire was not. From the seat I can see the tire, but not the wheel itself. Threw a bead and lost all my ballast. Cost plenty to get it refilled. I know. Dumb. But be sure about the tires...

This is likely it. From what I can see, there isn't a mechanism that allows a clutch to work the front, and not the back. Something is spinning on something somewhere, and this is the likely culprit.

Without a load, I can't tell my rear tires are flat(until I am on the side of a hill).

 

[dqdave1]

I have gone over everything and only thing I can find is mud packed in many areas that may have been causing diff lock not to fully engage. Has not done it since. One thing I did find is range selector input shaft on transmission is "loose" . It has alot of play in it and when in low range, I might not have had it completely in low range due to play in it. Not sure how to make this repair at all.