TC40D loader hydraulic fitting source

[RobertN]

Anyone get a source for the hose end quick couple fitting on a TC40D besides NH? I have not found them besides NH(ie expensive).

 

[RickB]

If you swap out both the male and female halves, you can put any coupler pair on it you can find with a 3/8 NPT thread on the back side.

The days of really cheap couplers are over; even 3/8" ISO couplers are spendy.

 

[RobertN]

I ordered the correct one from NH. Just get it done

 

[jinman]

I ordered the correct one from NH. Just get it done

Is this for your splitter? Just curious. . . .

 

[RobertN]

Yes...
My local tractor guy had one used one. He ordered another, but it was wrong.

 

[nickel plate]

When I added a grapple to my TC40S I used 3/8" hoses and 1/2" Pioneer QCs purchased from TSC for about $18.00 a set (1M and 1F). They matched up perfectly to the added NH rear remotes.

 

[jinman]

When I added a grapple to my TC40S I used 3/8" hoses and 1/2" Pioneer QCs purchased from TSC for about $18.00 a set (1M and 1F). They matched up perfectly to the added NH rear remotes.

Yep, rear remotes are 1/2", but the FEL quick connects are a special size. Robert doesn't have rear remotes and is running his splitter from his FEL quick connects.

 

[RobertN]

Ya, learned this trick from this guy on the internet

and is running his splitter from his FEL quick connects.