criddlesperger
Member
where should my temperature run while working my ym2010. also, is it normal for the tractor to jump when shifting gears on the go keeping a steady throttle, it is a powershift model. thanks chris:thumbsup:
temp gauge
- Thread starter criddlesperger
- Start date
- Views: 2055
normde2001
Elite Member
- Joined
- Mar 10, 2002
- Messages
- 4,159
It has a thermostat. Not sure what set at , but probably 180*. If by jumping you mean slamming into gear like speed shifting any standard trans. I would say that's probably normal.
Pete Judd
Veteran Member
- Joined
- Aug 18, 2010
- Messages
- 1,013
- Location
- The Thin Gravy Ranch in The wet PNW
- Tractor
- Yanmar 186d, JD 314
If I am in 3rd range, and I shift with the power shift with out using the cluch it will raise the front wheels off the ground.
YanmarFever
Elite Member
- Joined
- Mar 10, 2002
- Messages
- 4,089
- Location
- Eating a melon..
- Tractor
- Branson 4520r 5520C- Yanmar FX235-D - Bad Boy rogue mower
If you use the clutch during high RPMs it will stop the wheelies and its easier on your ring & pinion gear.
The power shift was not meant to be shifted (without) the clutch at real high RPMs.
Although, wheelies are fun if you have a roll bar
just joking...
The power shift was not meant to be shifted (without) the clutch at real high RPMs.
Although, wheelies are fun if you have a roll bar
just joking...
OP
criddlesperger
Member
thanks for the help. mine already has some slack in the ring and pinion, i will use the clutch or just start off in the gear i need to be on the safe side. my temp gauge stays between the 1/4 and 1/2 way mark. put about 3hrs on it building a house pad and it did great.
