temperature gage

   / temperature gage #11  
DSCN1067.jpgDSCN1068 2.jpg Hope this works. The gage is mounted by the air cleaner and the temp sender mounted to the thermostat housing
 
   / temperature gage
  • Thread Starter
#12  
I removed the temp light probe completely, there is a hole in the dash where the temp light was.I used the temp probe tap for the outlet for the block heater and the block drain tap for the block heater inlet. I tapped a hole in the thermostat housing for the temp gauge sender. Both modifications work very well and cause no problems.

Do you know what size those threads were in the temp probe tap? I am going to just replace the light switch probe for a gauge probe,
 
   / temperature gage
  • Thread Starter
#14  
   / temperature gage #15  
My engine is a KE-75. I think that is a Mitsubishi. I have never known of metric pipe threads. Remove your probe and take it to a hardware store and screw it into a 3/8 pipe fitting I bet it fits perfectly.
 

Tractor & Equipment Auctions

2019 Caterpillar DP35N 7,000lb Diesel Forklift (A54811)
2019 Caterpillar...
2015 INTERNATIONAL LF687 (A53843)
2015 INTERNATIONAL...
NEW HOLLAND 706 30 INCH 3PT DIRT SCOOP (A53473)
NEW HOLLAND 706 30...
2017 FREIGHTLINER CASCADIA SINGLE AXLE DAY CAB (A54607)
2017 FREIGHTLINER...
2018 FORD EXPEDITION (A51406)
2018 FORD...
2009 MACK GRANITE (A52472)
2009 MACK GRANITE...
 
Top