Thanks for help..JD 3320 Arrived

[mjncad]

Mcad, Thanks for the note as this blade has the same bent blade stand pole. I wondered what might have happened and now I kno. I will get another and do as you said reference yellow.

Jim

Jim:

I forgot to post pictures of the stands I made. It's nice to have a couple of spares if I ever screw up again.

I suggest you get the end plates for your blade. I bought them and they are worth the money as they give you more control over directing the spoils you scrape up, especially if you only put one on and angle the blade to direct the spoils to the side without and end plate.

 

[sfloggie]

Will do Mcad. I will check into the end caps. Nice job of the stands!

Jim

 

[sfloggie]

mcad,

I looked into the end plates...thanks. Also saw this link where one guy made his own.

http://forums.yesterdaystractors.co...=3227367&sid=ffb8c2a7a7ef5bd1aa02437238e7c2a4

Good day, Jim

 

[mjncad]

Jim:

It looks like those homemade end plates will be used for snow removal. I doubt they would hold up to doing earthwork.

I bought mine as I had no way to fabricate a set at the time. Now I have the tools to do a set halfway. I have no way to bend a mounting flange like Deere/Frontier/Woods did, nor do I have a way to punch square holes. Of course a fab shop could have done those tasks for me; but probably at a higher cost than just buying them.