TIG setup for my Everlast Powerarc 200ST

[woodlandfarms]

More than likely Shield has the answer but I am mulling over purchasing a basic tig setup for my stick 200ST. Maybe I shouldn't cause I don't even know what to ask for but was wondering and thinking seeing that Shield was ordering some sort of TIG setup what would be recommended for my 200ST (is it even powerful enough?)

 

[Shield Arc]

You can do a lot of Tig welding on stainless steel, and steel with 200-amps.

I replaced my old Tig rig with this one from eBay. Really nice set up.
WP 26V 25R 25' 200Amp Air Cooled TIG Welding Torch Gas Valve Ready to Go Package | eBay
These flow meters get great reviews.
HTP Argon CO2 MIG TIG Flow Meter Regulator Welding Weld | eBay

 

[k0ua]

I have that exact same flow meter, and a smaller 17V torch, as my Everlast is just the 160 amp. Works for me. There is a learning curve, but once you get going, you will enjoy TIG, it is actually fun. Oh sure, there is no foot pedal control, and no HF start, but a while back everyone used a TIG rig set up this way. And many still do.

 

[Shield Arc]

And many still do.

X-ray quality pipe welds are made everyday in construction with Tig rigs.