Toolcat 5610 F and 5610 G Series Pictures

[mmancuso13]

Nice!

 

[ruffdog]

The front 72" finish mower finally came. I mowed a area that wasn't mowed and it went right through....nice.

 

[ruffdog]

I have to cut lower branches on a few hundred trees because the toolcat needs more clearance. I made this work platform on a KK carry-all frame. All I have to do is get my wife to drive me around the land so I can cut them limbs.

 

[ruffdog]

I was also making sure the Snowsport plow will work using the 3pt and receiver hitch adapters. Thinking of snow is nice today....90's and HIGH humidity. Wheew!

 

[Xfaxman]

The front 72" finish mower finally came. I mowed a area that wasn't mowed and it went right through....nice.
View attachment 565447View attachment 565448

Keep us updated on this mower, please.

I may need one someday.

 

[Xfaxman]

First time moving round bales with the G Series. Bought 7, 5x6 Bales, they were delivered on a side dump bale trailer.

This is where they landed:

Moving the first one:

 

[Xfaxman]

Decided to weigh a bale using the shop crane and crane scale:

Zeroed scale with the chains on it:

Set the bale on it:

Raised it up:

Only 1,132 pounds:

 

[ruffdog]

Here is the carry-all installed on the toolcat. I had the wife drive the machine while I cut limbs.

 

[Xfaxman]

Here is the carry-all installed on the toolcat. I had the wife drive the machine while I cut limbs.

I noticed that the mirrors are pushed forward, out off the way of tree limbs, but they look smaller than original Bobcat mirrors.

Pictures from the day I hauled it home:

The left mirror got broke on the F Series and I replaced it with a slightly smaller UTV mirror.

 

[ruffdog]

The mirrors are just turned the other way so they are wide, not tall. They look to be the same though.