Tooth bar cost

[BoneheadNW]

Mine was $400 installed by the dealer. I don't know the make or how it compares to the other toothbars but it is extremely strong (I lifted a large stump out using just one tooth, not on purpose) and sharp (I have scars on my ankles to prove it). Not only that, the dealer painted it orange!

Bonehead

 

[FL_Cracker]

My tooth bar is a 72" with weld on teeth. I just paid 375.00 and the dealer installed with the package...

 

[Nasty135]

My vote goes to markham welding , 60" for $200 installed myself in about 22minutes 7 seconds /forums/images/graemlins/wink.gif No really it goes on quick and easy.

I'd rather pull my own teeth than pay that much for a toothbar!

Good luck with your decision /forums/images/graemlins/confused.gif

 

[Tom_H]

</font><font color="blue" class="small">( Markham Welding 4' toothbar w/replacable teeth was $212.50 late last year.)</font>

Is this just the toothbar or toothbar and shipping total? My 4' Markham late last year was $150, but shipping NC to CA was another $150. I did not quote my shipping cost because that is such a variable depending on the origin and destination.


My guess is that your $212.50 is cost and shipping total.

 

[milkman]

Order 2, the shipping is the same, DannyD ordered a 48" toothbar from Markham Welding and also ordered a 48"one for me and both of them with shipping was less than $400. They are heavy.

 

[JLoaf]

I needed a toothbar to fit over my bolt-on cutting edge. I ended up getting a Woods 6 ft for about $500 delivered to my dealer.
I could have gotten one from Markham for about $330 delivered, but I would have had to remove my bolt on cutting edge. I've seen a lot of bent buckets and I didn't want to lose the additional strength of my cutting edge.
I installed my tooth bar in about 30 min - and I'm slow!
I used a hole-saw for the bolt holes.

 

[milstencil]

Thanks for the help, guys!!!!
Am going to check out a couple of dealers on Friday and see how much gold they want to line their pockets with.
Now if someone can tell me how to remove the cover under the dash board, I will be able to install the alternator upgrade kit.
THANKS!
Rick

 

[WALT]

milstencil:

I just finished building a 72" 8 tooth toothbar for my L-39.
The materials cost approx. 13.82 per tooth plus shipping from Binkley & Hurst in PA. THis is the second tooth bar I have built with the teeth supplied by them. I ordered the teeth on Monday and they arrived on Tuesday. I used 3/8" x 4" flat stock for the upper & lower bases. The total cost was approx $170.00 for materials & 4 hours time with the welder.
I used the design by "Chim" posted here in the fall of 2002.
I'll attempt to attach a few pictures.
If you have access to a welder, this is a fairly easy project.

WALT

 

[WALT]

Picture #2

 

[WALT]

Picture #3