Rotary Cutter top link

[brix]

I am having trouble with a top link adjustment. When I am hooking up my mower, it seems that the top link is got to be extended all the way out. I've got the arms all the way in. Can't figure it out, what am I doing wrong The link is 32" extended, should be long enough. The tractor is a Kubota mx5000.

Brix

 

[rd_macgregor]

Does your mower have a chain bracing the top link to the back of the mower or is it a rigid link?
BOB

 

[MicroPilot]

What is the mower model? Can you provide us with a pic?

 

[RPW]

A picture would definitely help. Almost sounds like your missing the piece that goes on the mower that allows the mower to pivot up and down. Mine is a U shaped piece of steel some others have mentioned a chain setup.

Good luck.

 

[teg]

Does it have a "U" shaped bracket like this one below??? Also, I normally don't attach the top link when I'm mowing The tail wheel stays on the ground the whole time and just lift the the lower arms when I need to get over a rock.

 

[brix]

It's a woods mower, it has the pivoting u-shaped swivel. Don't currently have it hooked up. Next time I have it on I'll snap a pic.

thanks, Brix

 

[clemsonfor]

once the lower arms are connected lift them up a little so that it lifts the mower closer for the toplink. Kind of hard to explain why but it works for an inch or 3 closer for my attachement on my tractor

 

[sweettractors]

I have seen implements that required a long barrel toplink. This may be one of them. Ken Sweet

 

[TripleR]

I agree with Ken, get another top-link if you need to for the correct angle. Even with a hydraulic top-link, I have a regular one a little longer.

 

[sweettractors]

The standard toplinks have approx a 16 inch barrel and the long barrel is 20 inches. Ken Sweet