Tractor Forks

[daTeacha]

If you get a long enough bolt, there is a pretty good unthreaded section on it. They only tend to thread the area likely to have the nut on it, leaving the rest full diameter, at least around here. A 6 inch bolt will probably have 4 1/2 or 5 inches of unthreaded length just below the head. Measure the amount you need unthreaded and go shopping.

 

[Ford850]

Can't you get a top link pin from TSC that will fit? They carry different category pins, and in a couple lengths.
Tractor Supply Company - LINKAGE PINS TOP LINK PINS

 

[kozak]

The top links are different diameter. Cat. 1 is 3/4" dia. & if you go up to a Cat. 2 top link pin it jumps up to 1" dia. I need 7/8" diameter for lower link arms.

Going to try New Holland Dealership this morning. I am now trying to also source 1.25" dia. pins for FEL so I can try out forks on front.

Thanks for the link. If New Holland does'nt have anything I will try there next. They may have something close to what I need.

Vic