SandburRanch
Veteran Member
- Joined
- Oct 12, 2010
- Messages
- 1,543
- Tractor
- NHtd75
watts ( amps ) for 1hp pump
- Thread starter Soundguy
- Start date
- Views: 6584
Egon
Epic Contributor
Any pressure testing I was involved with always used water.
The pressure test not only checks for connection leaks it also checks the integrity of the pipe. If pipe integrity is below standard and using air a nice explosion of flying shrapnel can result.
The pressure test not only checks for connection leaks it also checks the integrity of the pipe. If pipe integrity is below standard and using air a nice explosion of flying shrapnel can result.
OP
Soundguy
Old Timer
- Joined
- Mar 11, 2002
- Messages
- 52,424
- Location
- Central florida
- Tractor
- RK 55HC,ym1700, NH7610S, Ford 8N, 2N, NAA, 660, 850 x2, 541, 950, 941D, 951, 2000, 3000, 4000, 4600, 5000, 740, IH 'C' 'H', CUB, John Deere 'B', allis 'G', case VAC
Any pressure testing I was involved with always used water.
The pressure test not only checks for connection leaks it also checks the integrity of the pipe. If pipe integrity is below standard and using air a nice explosion of flying shrapnel can result.
our county code for residential calls for air.
'ag gets by with no test past the pump itself and the plumbing to the pressure tank.
soundguy
tommu56
Elite Member
RavensRoost
Gold Member
- Joined
- Feb 7, 2006
- Messages
- 316
- Tractor
- John Deere 4500 and Mule 3010 (gas)
My 1/2 HP deep well pump takes about 1.1Kw to run, so I predict your 1 HP will be 2Kw or about 8.5 A (per leg) on 240v.
Starting is at least 2x or so, but I have no observed info on that.
Starting is at least 2x or so, but I have no observed info on that.