Weld Wire and Staples ?

   / Weld Wire and Staples ? #11  
I've been using hot-dipped galvanized nails in my nail gun to put up four board fence in treated posts. I'm not worried about the nails, but I believe the galvanized staples I refferred to earlier are electroplate galvanized - much thinner layer than hot dip. May not last, but as others have mentioned it is easy to go back and add more staples later, with the pneumatic stapler.
I bought the 19.95 metal & 2x4 fence wire stretcher from TSC, very happy with it's performance. I stretch the wire by attaching the bracket & 2x4 to the wire, and tensioning it with some 2" ratcheting straps that I tie off to my tractor or other immobile device. The welded wire does fail easy though - one of our horses ran right through it, didn't leave a mark on the mare but burst an 8 foot section of wire.
 
   / Weld Wire and Staples ? #12  
I filed a notch in my 1/4" crown stapler to center it on a wire. Works great!. Mainly use it for chicken wire.
 
   / Weld Wire and Staples ? #13  
Do you have any problems with those powered staplers 'cutting' thin wire?

Soundguy
 

Tractor & Equipment Auctions

2017 John Deere Gator TS Utility Cart (A50324)
2017 John Deere...
1998 INTERNATIONAL 9400 (A52472)
1998 INTERNATIONAL...
UNUSED JCT 40' CONTAINER (A51244)
UNUSED JCT 40'...
NEW Ripper Shank (A53002)
NEW Ripper Shank...
2018 FREIGHTLINER CASCADIA TANDEM AXLE SLEEPER TRUCK (A52577)
2018 FREIGHTLINER...
2007 Chevrolet C4500 4x4 Dump Truck, VIN # 1GBE4C3247F411826 (A51572)
2007 Chevrolet...
 
Top