Welding Table Top

BB_TX · May 19, 2003

Would galvanized steel be good for a top for a welding table? Or just use plain uncoated steel? /forums/images/graemlins/confused.gif I am getting tired of setting my wooden table on fire. /forums/images/graemlins/blush.gif

Anonymous Poster · May 19, 2003

Galvanized steel gives off poisonous fumes when heated to a high enough temperature. My book says don't weld it (or heat it up much) without very good forced ventilation.

SnowRidge

Tractors4u · May 19, 2003

How about a sheet of Aluminum?

BILL_K · May 19, 2003

I use a 2 foot by 3 foot sheet of 1 inch thick steel for the top of my welding
table. This makes for a nice flat surface to work on and it
is heavy enough that it will not tip or move when I clamp
heavy items to it
Bill K

jrlichina · May 19, 2003

Inch thick, that's kind of light don't you think???? /forums/images/graemlins/grin.gif

GaryM · May 19, 2003

My memory might be faulty, but I think I've seen a welding table with a copper top. Do dingle berries not stick to copper? Or is my memory shoy?

BILL_K · May 19, 2003

A little bit?
The one that my buddy replaced it with is four foot by eigtht
foot and is one and a half inch thick. /forums/images/graemlins/ooo.gif /forums/images/graemlins/grin.gif

Bill K /forums/images/graemlins/laugh.gif

BB_TX · May 19, 2003

Bill K - Do you do anything to ****** rust? Or just let it go?

40Kchicks · May 19, 2003

You already heard why not to use galvanized steel. Thick steel is your best bet. Then you can tack things to it to hold them down at any angle. After your done break the part off and grind the small tacks. If you have a scrap yard around you'll be able to get a better price on the steel.
Eric