What do y’all attach to your front tow hook?
- Thread starter MUDONTHETIRES
- Start date
- Views: 6247
OP
MUDONTHETIRES
Gold Member
kOua is right on. I have a pin with spring clip. I just pull the clip and let the pin drop, then stick my tow/tie down chain in behind the holes and install the pin. I have to do it this way as the chain's hooks won't fit with the pin installed. I have to install the pin upside down, as there is no clearance for pin head on top. It's clear as Mud.
Or just hook your chain to the brush guard.
hugs, Brandi
Thank you for your input, that’s what I’m going to do! I have to install my pin upside down as well because I welded expanded metal on the brush guard and now there is no clearance from the top.
OP
MUDONTHETIRES
Gold Member
That's damn clever, thank you!
Redlands Okie
Veteran Member
Other than using it to attach a cable or tow rope I cannot think of any other use for the setup. As already pointed out a pin and clip and your good to go.
OP
MUDONTHETIRES
Gold Member
Thank you!
WranglerX
Super Member
You could always space it out by putting a block behind it and longer bolts then you can drop pin in correct way.... You do know spring clips fail and gravity works against you.....
Dale
Last edited:
grsthegreat
Super Star Member
That’s all I use it for
Hay Dude
Super Star Member
- Joined
- Aug 28, 2012
- Messages
- 18,369
- Tractor
- Challenger MT655E, Massey Ferguson 7495, Challenger MT535B, Krone 4x4 XC baler, (2) Kubota ZD331’s, 2020 Ram 5500 Cummins 4x4, IH 7500 4x4 dump truck, Kaufman 35’ tandem 19 ton trailer, Deere CX-15, Pottinger Hay mowers
Smokeydog
Elite Member
Prefer a good front tie down point when trailer over going across the front axle.
OP
MUDONTHETIRES
Gold Member
That’s a great idea! I know they fail and every time I get out of the seat I catch myself glancing at the pin.
