What happened to Soundguy?

[Soundguy]

At least I did not post any pictures...

 

[Loaderman22]

Glad to hear you are on the mend SoundGuy. You have helped me in more ways than I can count with my front distributor 2N. Without your help it would probably have been scrapped by now. I haven't started it in about a month, but I am confident that she'll fire right up. She's no beauty queen, right now it's powder blue since the previous owner hit it with a brush & some leftover porch ceiling paint. She purrs like a kitten, & even with the 7' rear blade, those tires keep her moving forward, more than I can say for the stubborn JD that just likes to dig in it's "heels" whenever it gets the chance. Anyway, glad to hear you're "ok" & thanks again for all your help over the years!

 

[MA1920]

At least I did not post any pictures...

There's still time...….

 

[Soundguy]

Well, loading hay monday, I managed to put my first user induced dent into my.... truck.

I was putting a fairly large round into the bed and didn't see the roll catch a tool box edge ( mounted on lip of side bed.. and it bent the lip of the bed and caused a little crumple. I used the loader and a chain to pull the bed lip back mostly straight.. but there is about a 1' x 3" rippled section at the top of the side of the bed. Remarkably.. it's the largest damaged section on that 99 f350 truck I drive.

 

[ovrszd]

Well, loading hay monday, I managed to put my first user induced dent into my.... truck.

I was putting a fairly large round into the bed and didn't see the roll catch a tool box edge ( mounted on lip of side bed.. and it bent the lip of the bed and caused a little crumple. I used the loader and a chain to pull the bed lip back mostly straight.. but there is about a 1' x 3" rippled section at the top of the side of the bed. Remarkably.. it's the largest damaged section on that 99 f350 truck I drive.

Things like that aggravate me so much,,,,, at myself.....

 

[goeduck]

Well, loading hay monday, I managed to put my first user induced dent into my.... truck.

I was putting a fairly large round into the bed and didn't see the roll catch a tool box edge ( mounted on lip of side bed.. and it bent the lip of the bed and caused a little crumple. I used the loader and a chain to pull the bed lip back mostly straight.. but there is about a 1' x 3" rippled section at the top of the side of the bed. Remarkably.. it's the largest damaged section on that 99 f350 truck I drive.

If that the the largest damage in a 20 year old pickup, you are doing good. My 99 has a slight front Bumper impression, not bad either.