YM1510D question

[Jjpbe]

Hi,

I am wondering what these three holes are for. They are located on the bottom of the tractor under the PTO shaft.
I have attached 2 pictures. ?

 

[winston1]

I suspect they are for drawbar attachment.

 

[CoyPatton]

I suspect they are for drawbar attachment.

 

[bmaverick]

Hi,

I am wondering what these three holes are for. They are located on the bottom of the tractor under the PTO shaft.
I have attached 2 pictures. ?

Those are the 3 mounting points for the trailer tow sleeve that the tube and ball would fit into. Not sure if your YM1510 had the square setup or the round one.

I browsed the YM1510 Parts Manual, but the image wasn't there. On a YM2500/YM2610 it's the round version like this ...

 

[bmaverick]

Hi,

I am wondering what these three holes are for. They are located on the bottom of the tractor under the PTO shaft.
I have attached 2 pictures. ?

If the Top-Link wasn't there, you would see the tow plate attached with a 2-inch standard ball.

 

[bmaverick]

If the Top-Link wasn't there, you would see the tow plate attached with a 2-inch standard ball.

View attachment 677114

A better view finally!

 

[bmaverick]

sorry about the multiples, TBN would not accept the image, so I keep clicking.

 

[Jjpbe]

Great info, thank you bmaverick.

 

[CoyPatton]

My round tube draw bar mounts like these photos for the round one show. But the bottom of my case is not recessed ad your tractor pictures show. I wonder if yours used more of a flat stock draw bar.
Threads are most likely a standard metric thread. Clean them out measure depth and diameter, get some 3/4 or 1” bar stock and make your own draw bar if you want one.
Measure the width and length of that slot. Allow yourself about 1/4” of play on each side for with of bar stock. 2.25-2.5 times the length of the measurement of the recess slot.
Make a cardboard pattern an mark the holes. Drill or have some holes drilled for mounting holes. If you want the 2 plate mount like in the round stock photo above, let me know and I will take some measurements of mine and post for you. Or you may not want anything there and use a 3ph drawbar.

 

[Jjpbe]

Great info CoyPatton. I was looking for one which would fit but now with your info maybe I will make one myself , thank you