Your last generator Maintenance Run

[Racer4]

Were those exercise hours or loaded hours.
Professionally installed standby generators are sized for worst case load scenario. During an outage I would be conserving power (minimal load) to conserve resources.
Perhaps the engine was not adequately loaded during this break-in period.
Just a thought.

Good point. Assuming 10 minutes a week over 2.5 years brings it to 55 hours with load on it.

She’s probably frugal with her energy usage anyway. So it probably wasn’t worked hard at all.

Mine gets a workout. Especially if we’re all home for a snow day. Wife does laundry on those days. Then it gets to run the well pump, washer and dryer plus everything else.

 

[3930dave]

Air cooled 993cc vanguard. Oil change interval is 100 hours. Capacity is 78-80 ounces of oil. The Briggs service kit has Briggs synthetic oil included. No leaks anywhere so it had to get burnt.

Thanks - I'm not familiar with that class of Briggs.

Rgds, D.

 

[arto98607]

Sorry, not trying to steer conversation away from generators, but this may be the same type engine?

The engine in my Vermeer stump cutter may be the same model 35 hp Briggs Vanguard.

These are Briggs & Stratton design, manufactured by Daihatsu (a subsidiary of Toyota) in Japan.

They get pretty hard workout in this service and I stick to 40 - 50 hour oil change.

This one has 870 hours on and so far never needed oil addition, however it gives slight puff of blue smoke when restarted while still hot after hard working!
To me that indicates it may be time to check & change the valve stem seals soon.