YT Series 3rd Function Help

[Knotch]

I was clearing some brush this weekend and a stick ripped the two wires out of the plug that goes into the 3rd function switch. There wires are red and green. Can anyone snap me a picture of which slot the wires go back into? In case you don't know, the 3rd function switch is just behind where all of the hydraulic lines from the loader thread in on the right side of the tractor. Below is a pic of the plug minus the wires of course.

Side note- Does anyone have any ideas on how to better protect that area of the tractor? I don't think Yanmar makes a skid plate or something similar. Just curious if anyone has done something DIY to protect the hydraulics and other bits in that area.

 

[rockyridgefarm]

not much help here - other than to say that these CUTs seem to be engineered with farming rather than bushwhacking in mind!

 

[Kiwibru]

I will be moving my tractor to the barn later today. I will see if I can get a picture for you!

 

[sloeffle]

I tired to take a pic for you but I can’t get a close enough pic to help you out.

 

[rockyridgefarm]

I tired to take a pic for you but I can’t get a close enough pic to help you out.

me too - but I am 20 miles away