YT359C Hdyro Side Link

[wileythedog]

Wanting to put on a hydro side link. I already have the top link. What brand/model fits, any suggestions. For those of you who have put one on, what did you install?

Thanks!

 

[wileythedog]

Found this, will it work?

SLH03 Universal Hydraulic Side Link Cylinder, Fits CAT I Base End/ Clevis Rod En | eBay

Find many great new & used options and get the best deals for SLH03 Universal Hydraulic Side Link Cylinder, Fits CAT I Base End/ Clevis Rod En at the best online prices at eBay! Free shipping for many products!

www.ebay.com

 

[tier4]

Wiley here is the pieces you will need to make the system work correctly

 

[wileythedog]

Wiley here is the pieces you will need to make the system work correctly

Thanks,

Looks like the attached is for the hydro top link, I already have that installed. I am asking about the side link that would allow tilt.

 

[MtnViewRanch]

Just shipped one out yesterday. I seriously doubt that you will find an off the shelf unit that fits right.

I don't think that you can get a 5" stroke cylinder off the shelf, so you will need to make some compromises with either a 4" or 6" stroke cylinder if you are going to build one yourself. Any of these will provide an equal amount of tilt angle to both sides if built properly.

I think that I would forgo the top pin location in the clevis and use a 6" stroke cylinder.
I use 2 1/2" dia cylinders with a 1 1/2" dia rods for these tractors.
You need a narrow cat 1 top link ball swivel and build the clevis accordingly.

Or you could simply order one from me, just be ready to wait.

 

[wileythedog]

Just shipped one out yesterday. I seriously doubt that you will find an off the shelf unit that fits right.

I don't think that you can get a 5" stroke cylinder off the shelf, so you will need to make some compromises with either a 4" or 6" stroke cylinder if you are going to build one yourself. Any of these will provide an equal amount of tilt angle to both sides if built properly.

I think that I would forgo the top pin location in the clevis and use a 6" stroke cylinder.
I use 2 1/2" dia cylinders with a 1 1/2" dia rods for these tractors.
You need a narrow cat 1 top link ball swivel and build the clevis accordingly.

Or you could simply order one from me, just be ready to wait.

I'd be interested in ordering one, can you PM me any additional information. Thanks!

 

[normanb]

FitRite Hydraulics is the best if you can wait for them to make it. Get it with a double pilot check value, if not, you will have issues with keeping things level because of creep.

Chris