Recent content by TO_Bud

Here is a link to your loader. New Holland 250TL - NH FARM LOADER(07/06 - 04/16) Parts Diagrams . Doesn't really indicate the power beyond port, but I would get underneath and look at the joystick valve. Most Older Boomers will have the port marked as "PB." The port may be used already...

He posted on yesterdays tractors 758b and 758c backhoe - Yesterday's Tractors He is a member on this forum as well.

Rick B is the guy in the know. This is what he posted on another forum about b and c. B is earlier than C. B was built by ARPS; C was built by SMC also known as Schwartz manufacturing.

I agree with oldestgoat. The pic doesn't show much if any dripping of oil. If it is just leaving a coating on the cylinder rod I would remove the high spots of the scratch and see how it goes. Do that before moving the stabilizer in and out to prevent any further seal damage.

The Cycle Stop Valve I installed on my system was just before the the pressure tank in my basement. There was no need to pull the pump and it was pretty easy to install. The valves work by adding back pressure to your pump at a pressure you set so the pressure can't reach the upper limit of...

I bought a dump trailer from Appalachian, drove down and picked it up. Trailer is well built and I'm pretty happy with it so far. I also own a PJ brand car hauler with 5K axles. The Appalachian trailer is a step above the PJ.

You could add a 2 inch receiver to the rear cross member of the trailer. Fab up an arm of sorts to extend back or up to hold the tail wheel or mower deck. Elevate the arm enough so the wheel does not drag on turns. Could remove the arm like a normal trailer hitch when not needed.

Any oil leak is hard to find when oil coats a bigger area. When looking for the origin of leaks you will need to do a thorough cleanup first then run the tractor while watching for the leak. Brake Kleen and pressure washer work good for this, then wait for area to dry before starting tractor...

Sorry, just now noticed you had reponded to an old post of mine. It's been a few years since I put that kit on but if I remember right the kit replaced the end block of the rear remote valves I put on. So that is the question, is your rear remote valve the same as mine. Messicks website has...

Is this what you are looking for regarding the valve block. Hose Kit 1021867 Assembly, Woods BH70-X Backhoe Backhoe Attachment: Hose Kit 1021867 Assembly Assembly Parts and Diagram

I have a 758B backhoe and I have the original operator manual for it which includes the C. Check out this thread and go down to post number 6 to see the pages you may need. Backhoe - power beyond and backhoe

The initial stall problem may very well be from gelled fuel as stated above. As far as no crank issue now is your pto light on when you turn the key? If so you have probably blown fuse #2. If that's the case you can read this thread from Jinman (RIP), TC35D Quit while operating

Just bought 1 of these from Titan http://www.titandistributorsinc.com/default/titan-attachments/three-point-attachments/skid-steer-3-point-attachment-adapter-for-skidsteer-bobcat-kubota.html#.U660kLHfvEI so I could use some of my attachments off the loader. I've been kicking around the idea of...

Here are the directions I received from my dealer when I installed my backhoe, They cover the 757c Hoe. There was a kit to buy but is wasn't too expensive. Good Luck, Bud

Actually came out pretty good considering how far up the lines were pushed. The block is held in place by a bracket. I've attached the drawing out of the manual, bolt (1) secures the bracket. That bracket was bent up and somewhat twisted. Pic second from right shows the offending line and...