chopped
Veteran Member
I was wondering if anyone has seem or has any ideas on some sort of adapter that would go in the plate like a wedge. and would increase the buckets rollback?This would increase the bucket capacity and also less spill over. i know it would cause problems when its up high but for moving material Id think it would be a good things to have.
Im thinking of some metal that would extend out the lower ''slot'to do this. but would be concerned as it would add pressure to the pin and also not distribute it over the whole paddle plate.
This video shows some rollback angles.to get an idea of what I want to buy or to make.
https://www.youtube.com/watch?v=BwmVAW_mlyw
Im thinking of some metal that would extend out the lower ''slot'to do this. but would be concerned as it would add pressure to the pin and also not distribute it over the whole paddle plate.
This video shows some rollback angles.to get an idea of what I want to buy or to make.
https://www.youtube.com/watch?v=BwmVAW_mlyw