Every time I start this tractor from COLD, its extremely difficult...cranks over before it finally kicks in to almost flattening the battery. In fact generally I need to put the battery on the...
Ok so I replaced my fuel filters and primer doing routine maintenance, and all the gaskets are in the right place, and I went from bleeding the filters to the injection pump to the injector lines...
Ok so I have a long 445 diesel. It has run great, cranks up as soon as you turn the switch. But I pulled it in the shop to do some maintenance, new fuel filter and primer. And while it was in...
Hey guys. Been reading for years. Usually can fix stuff no issue but my experience working on this old girl is limited.
I have a. 1976 long 445. My father purchased it around 1978. Aside...
I have recently purchased a long 445 and the 3 point will not raise or lower. Changed the fluid the fluid "which was really low and looked like oil". All I know is he said it slowly went out and...
Hey everyone, new member and first post. I bought a long 445(project) for VERY cheap a few months ago. To explain what I've done to it will be a whole other post someday when I've got the time...
Hi, can anyone tell me how to adjust the valves on the Uzania 3 cylinder diesel engine. I don't know if they are to be at top dead center or a few degrees before or after and the clearance for...
Have purchased some land and it came with 69 Long 445. Power steering did not work. Have rebuilt ram, installed pump and prince PRV. Upon start up wheels turn right an HD then pressure builds and...
Have purchased some land and it came with 69 Long 445. Power steering did not work. Have rebuilt ram, installed pump and prince PRV. Upon start up wheels turn right an HD then pressure builds and...
Hi I have a Long 445 DT. Has some problems. The 3 pt. hitch arms don't work. Removed everything to the short arms that connect to the crossbar. They don't seem to have any connection inside...
Good afternoon
I have a Romanian built long 445. I recently took the top cover off the injector pump to replace two O-rings. I put things back the way I thought they should go and now I cant...
Hey, I've got an older long 445 Romanian tractor with no rear lift at all. It slowly went away over a year or so with slow lifting and wouldn't hold up implements. I think I have pinpointed to the...
Please help, I bought a long 445 with FEL for $3000. I do not know how to change the 6 speed transmission from high to low. Also did I pay too much. Thanks
i have a utb long 445 i would say its a 74 model but not sure.
i started having fuel smoke real bad less at idle
if you bush hog up hill it is way under powerd
it idles good will even idle up...
Hello,
I recently bought a Long 445DT tractor.
it is a UTB Fiat type tractor.
It runs great drives great. it is a little "clunky" and not very smooth working but it works.
Here is my problem...
I need a power steering pump for my Long tractor model 445, 4WD version. The pump appears to be a Borg Warner and as far as I can see it is model SR16B5CS43L. Or it might be R16B5CS43L. The...
I have a Long 445. It has a single hydraulic reservoir. The power steering, hydraulics, all work off the same fluid. My lift would not lift my bush hawg, so I changed the fluid, which was very...
:confused:Could someone please tell me if my tractor is a 445 or 460 Long ? The hood lifts to the front and it has headlights in the grille. I have been told by the guy I bought it from that it...
I have an UTB 445DT which is the 4WD version of the Long 445. This is a selectable 4 WD or front wheel assist arrangement.
On mine the front axle can move forward or backward by over 1/8"!
I...
I own a 1978 Long 445. The hyraulic reservoir in the frame collects moisture and forms an emulsion. I am getting ready to change the hydraulic oil. Does anybody have any suggestions on cleaning...
HI All,
I have a man who needs some parts for his Long 445. It has a D115 engine and the guy said it needs cam, lifter and gaskets. I have not seen the machine but this is what he said he needs...
Just thought I'd turn up some 3/4" pins on the lathe to fit a top link to my Long 445 ready to run a bush hog & mower I'm picking up Wednesday night.
Pins are great & fit the top link easy, but...
Just thought I'd turn up some 3/4" pins on the lathe to fit a top link to my Long 445 ready to run a bush hog & mower I'm picking up Wednesday night.
Pins are great & fit the top link easy, but...
Should the TPH arms power down as well as up on the Long 445? Mine lift fine, but won't come down without some weight on them. This is my first real tractor so I don't know if this is normal. If...
I just bought a UTB ( Long) 445 DT (4 WD) which has a FEL with spool controls in the cab, plus a single rear hydraulic Q/D outlet. I want to run a back actor on this which has two hydraulic pipes...