Does anybody have remotes on their BX?

[jnjpream]

I'm looking into putting remotes on my BX22 for top, tilt, and pivot. But I can't figure out a good place to put the valves.. Does anybody have pictures of the valve placement on their BX?

Thanks.
Jeff

 

[Renob]

Hi,

I used the outlets for the backhoe to plumb the hydraulics for my valve. It is mounted on the ROPS.

Not the best picture, but will give you some idea.

http://www.tractorbynet.com/forums/...-bx24-rear-remotes-hydraulic-top-100_0810.jpg



.

 

[escavader]

Iused the outlet on my backhoe to power my chute control on my snow blower.It is an open centered system,and will save you alot of money installing a remote.
ALAN

 

[magnatic]

I just had the valves installed on my bx2350. The plate to which the couplings are attached mounts on the right side of the ROPS and the levers for the come up through the available slot in the right rear fender. I can take a photo and send it to you but I don't know how to attach a photo here.
I have the BX7326 Valve kit which allows me to operate the chute deflector and the chute rotation.

 

[jnjpream]

magnatic,

I would realy like to see the picture.. Sticking up through the extra slot sounds better than being exposed on the ROPs. Is there a way to send an email to a member on TBN? I'm not sure I want to post my address in the forum..

Jeff

 

[Renob]

magnatic,

Is there a way to send an email to a member on TBN? I'm not sure I want to post my address in the forum..

Jeff

Just left click on the person that you want to send a "private message". You will see that option.

 

[tommu56]

I just had the valves installed on my bx2350. The plate to which the couplings are attached mounts on the right side of the ROPS and the levers for the come up through the available slot in the right rear fender. I can take a photo and send it to you but I don't know how to attach a photo here.
I have the BX7326 Valve kit which allows me to operate the chute deflector and the chute rotation.

I would like to se a picture too if possible

You can you put it on photo bucket and link it to forum.
or put it in pictures in the home page pull down tab and no one will get your email address

pm me if you need help and are worried about address showing up.

tom

 

[skippy957]

Here is my set-up.

 

[lp333]

... I used the outlets for the backhoe to plumb the hydraulics for my valve. It is mounted on the ROPS...

Renob, that sounds great. It would seem that you accomplished this on a BX24. Would it be possible for you to post details on which ports on the tractor were connected to which ports on the remote valve?

 

[lp333]

I used the outlet on my backhoe to power my chute control on my snow blower...

Alan that sounds great also. It would seem that you accomplished this on a BX23, where the hydraulic plumbing for the BH is a bit different from that of the BX24. Would it be possible for you to post details on which ports on the tractor were connected to which ports on the remote valve?