Bob77064
Elite Member
Welcome Rick
Am I In the Club Now?
- Thread starter mrbeanley
- Start date
- Views: 3467
Mike476
Veteran Member
- Joined
- Jun 6, 2010
- Messages
- 1,080
- Location
- Annapolis Valley, Nova Scotia
- Tractor
- MF 135 Z134 Continental, MF 1660 Cab
Full disclosure - check, humility - check, sense of humour - check, You're in Rick! :drink:
Welcome.
Welcome.
k0ua
Epic Contributor
Extra bonus points for moving with your ballast barrel on the ground:shocked:
James K0UA
sixdogs
Super Star Member
- Joined
- Dec 8, 2007
- Messages
- 13,804
- Location
- Ohio
- Tractor
- Kubota M7040, Kubota MX5100, Deere 790 TLB, Farmall Super C
Wow...all this takes me back to all the "first day" things I did wrong.
How about clearing the barn overhead beam on a "press-fit" basis with the top of the ROPS? I know for sure it was a press-fit, by the way.
How about clearing the barn overhead beam on a "press-fit" basis with the top of the ROPS? I know for sure it was a press-fit, by the way.
OP
mrbeanley
New member
Yeah, well, I am the guy that cut the header out from above the shed door to gain the three inches of clearance I needed to squeeze the gc2600 in there! (I reinforced the roof rafters over the door, of course. I just love seeing that look on people's faces when I tell them I took the sawzall to the header!)
wyeguy
Gold Member
Thanks for showing me that I'M in the club. Mowed for a couple hours awhile back with the durn brake on....!
cdaigle430
Veteran Member
Lets see-100 hours so far and bent my BB cause I got stuck in a hole, hit the side of the shed wall three times with the FEL. Forgot to read the owner manual which tells you to put the PTO shield in the down position when using rear attachments. Bent the rear blinker against my ceder fense. Hit the garage trim with the FEL, hit the BBQ grill with the rear BH.
I think thats all I can remember.
I think thats all I can remember.
JoeBuyer
Banned
- Joined
- Dec 11, 2011
- Messages
- 698
- Tractor
- L5450
You need to drive away from your hydraulic attachment without disconnecting the hoses to get expedited entry into the club.
JoeBuyer
Banned
- Joined
- Dec 11, 2011
- Messages
- 698
- Tractor
- L5450
Or you need to drive all the way back to the barn with your round bale having fallen off your rear bale spear in the field. Extra points for having done this AND if you get off your tractor and get back on to open gates and not notice.
I once had a helper who managed to have a wheel driven hay rake come loose in a dip in the field on the away back to the barn. I had seen it there and had to have a little (well a lot) of fun with him. He couldn't see the rake in the dip and was absolutely baffled as to what happened to the rake. I was joking with him that he could not have raked the field without a rake, that he just went round and round and I would have to dock him pay and charge him for the fuel. He honestly thought he was losing his mind for a while. Now it is a regular joke very time we see each other.
I once had a helper who managed to have a wheel driven hay rake come loose in a dip in the field on the away back to the barn. I had seen it there and had to have a little (well a lot) of fun with him. He couldn't see the rake in the dip and was absolutely baffled as to what happened to the rake. I was joking with him that he could not have raked the field without a rake, that he just went round and round and I would have to dock him pay and charge him for the fuel. He honestly thought he was losing his mind for a while. Now it is a regular joke very time we see each other.
